SRB Systems Home

The Centurion Sideform is designed for simple clicker connection to magnet clamps via an Adaptor Plate that is affixed to the magnet clamp.

The clicker locks into the rear of the Centurion Sideform simply by rotating the clicker in a clockwise direction inside the rail at the rear of the sideform.

The clicker has a protruding thread that runs through the slotted hole in the side of the Adaptor Plate and is attached to the adaptor plate via a plastic knob.

The magnet clamp (with handles in disengaged position) is placed along the rear of the sideform and the clicker plate turned clockwise, via the thread, locating it in the rear clicker channel in the rear of the sideform.

When the sideform is adjusted to its correct location the magnet is first engaged to the casting table. Slight pressure is then exerted onto the top of the sideform to seal against the casting table and adaptor knob tightened firmly securing the clicker to the Adaptor Plate.

Titan Slotted Magnet Adaptor / Connector Plate

The slotted hole in the side of the adaptor plate allows movement of the clicker plate in the vertical plane to accommodate the varying clicker positions on the different sideform sections.

Centurion Bolt On Clicker

This type of clicker plate has a threaded bar protruding from the rear and operates on the principle of connecting the clicker to either the Slotted Magnet Adaptor, Titan Screw Fix Bracket or Panelware Site Cast Bracket via the tightening of a threaded knob.